I've been emailing with Don @ PDM-Racing.com regarding getting camber bolts for the pulsar.
I'm about to order a set for the front and a set for the rear but I'm having a hard time finding what the size requirement is for the rear of the car.
I think the front is 12mm, but can someone please confirm?
As for the rear, I have no idea - does anyone have any suggestions where I can look?
Thanks!!!
John
For the record:
Cost for a pair of camber bolts from PDM is $37 + GST + $14 shipping (to Ontario)
are you looking for whiteline specific items? kuz there's part #'s on the whiteline site itself.
are these the stock bolts?
if so I'll look tomorrow when i take my shocks out for rebuild...
Mine isn't bigger than yours.. I just like to drive
from the whiteline site F Camber adj bolt kit-12mm KCA412 2 +/- 1.5 deg
R Camber adj bolt kit-12mm KCA412 2 +/- 1.5 deg
https://www.whiteline.com.au/store/default.asp?part=KCA412
http://www.whiteline.com.au/store/images/products/KCA412.jpg
What should the camber be set at for when you go and you need to get a wheel alignment done to the car.
Depends what you're after. I wouldn't go past 1 - 1.2 degree of negative for the street, this will have 0 effect on tire wear. If you're running toe in or toe out, you'll have massive inner tire wear and cupping on the tires. On a autox setup i used to run up to 2degrees in the front and 1 in the rear on my crx.